Subject	same here, there a bit troublesome (n/m)
Posted by	550HPTT on January 27, 2008 at 8:52 PM
	This message has been viewed 33 times.
In Reply To	I have used those in the past... tend to come loose. (n/m) posted by jcieslik on January 27, 2008 at 08:51 PM
Message
Follow Ups	S-AFCII harness install - Barry'z (NJ) 20:10:08 01/27/08 looking clean Barry - 90AztecTT 20:15:22 01/27/08 is there a write-up for "knock sensor correction settings"? (n/m) - enthuZiast 20:39:10 01/27/08 I haven't looked that deep yet. (n/m) - Barry'z (NJ) 21:06:09 01/27/08 Yes - Broke_as_**** 21:27:03 01/27/08 Why not use these? - Bountywolf 20:39:41 01/27/08 I have used those in the past... tend to come loose. (n/m) - jcieslik 20:51:04 01/27/08 same here, there a bit troublesome (n/m) - 550HPTT 20:52:04 01/27/08 Yes, and as Crim noted... - Barry'z (NJ) 21:03:12 01/27/08 Looks good, except the manual explicitly says not to use - Crim 20:46:12 01/27/08 isnt that the same thing hes doing?? (n/m) - Bountywolf 20:49:02 01/27/08 They are talking about these... - Barry'z (NJ) 20:56:48 01/27/08 P.S. The type of connector I'm using is supplied - Barry'z (NJ) 21:05:30 01/27/08 I've been using them for a while now and I haven't had any - spyhunterTT(nj) 17:24:31 01/28/08 I'm been using them for my boost controller... - Barry'z (NJ) 18:36:56 01/28/08 what are those connectors called? - Tikigod (Denver) 21:51:39 01/27/08 Bullet terminals, or bullet connectors... - Barry'z (NJ) 22:28:19 01/27/08 thanks (n/m) - Tikigod (Denver) 22:39:55 01/27/08 not permanently installed? So why go through all that - Cap927(Boston) 13:12:37 01/28/08 Those connecters are fine... - Barry'z (NJ) 17:08:51 01/28/08 personally I don't trust either, from installing many - Cap927(Boston) 09:51:21 01/29/08 why tune it if ur not going to use it? - naZeer (Dallas) 20:09:11 01/28/08 I'm going to have the car tuned, and plan on - Barry'z (NJ) 22:16:53 01/28/08
Post a Followup	You cannot reply to this message because you are not logged in.