Subject	Im glad i only have one DP to worry about...
Posted by	1badz32 (MN) on January 27, 2008 at 8:33 PM
	This message has been viewed 31 times.
In Reply To	AEM EMS and O2 Sensor Question posted by collegeboy on January 27, 2008 at 02:58 PM
Message	But even then i put the bung too close to the exhaust housing, so the reading doesnt smooth out very well. "Why is it every time somebody wastes a ton of time and money reinventing the wheel, poorly, the critics are "haters?"- Kenny 09:29:05 08/15/06 AIM: Onebadz32
Follow Ups	AEM EMS and O2 Sensor Question - collegeboy 14:58:38 01/27/08 Re: AEM EMS and O2 Sensor Question - kickerzx 15:09:02 01/27/08 WB O2 sensors don't like heat, so you should not install - Dark Diver 17:03:53 01/27/08 I know that... - collegeboy 17:33:15 01/27/08 Plug the stock 02 sensor locations.. - Kong ZTT GT28RS MD 17:20:22 01/27/08 You did? And yes I got it shipped out again. - collegeboy 17:32:30 01/27/08 haha.. - Kong ZTT GT28RS MD 18:53:01 01/27/08 My SZ 3" TP's are angled down, have had to change my WB o2 - 550HPTT 19:21:48 01/27/08 I mean the tip (sensor part) - Kong ZTT GT28RS MD 19:30:36 01/27/08 Yes i was following that much lol, was just pointing out - 550HPTT 19:39:38 01/27/08 Im glad i only have one DP to worry about... - 1badz32 (MN) 20:33:38 01/27/08
Post a Followup	You cannot reply to this message because you are not logged in.