Subject	I mean the tip (sensor part)
Posted by	Kong ZTT GT28RS MD on January 27, 2008 at 7:30 PM
	This message has been viewed 32 times.
In Reply To	My SZ 3" TP's are angled down, have had to change my WB o2 posted by 550HPTT on January 27, 2008 at 07:21 PM
Message	angling Down.. Not the end where the wires are comming out of it.. The sensor tip (that sees the exhaust gases should be pointing towards the ground).. NO, This picture is not photoshopped. It took many times to take this picture. Setting up the timer, shutter speed etc, then jumping on my bike and getting the tire to spin. : MySpace for those who have em' AIM:Shawn300zxTT "-Any closeups on the nuts? - zboost(tx) 19:17:53 08/08/05 -Not really something you want to ask another man about... (n/m) - LordZ 19:24:00 08/08/05" "I just took 45 min and scrubbed the heck out of my rear" teambushido(San Diego, CA) 19:24:51 12/11/04 -1991 Stage _ TT 5spd (Upgraded to hell and back) -1990 Super White 2+2 Na Stage 3 Auto (Daily Driver, contemplating selling.. ) -1990 Cherry Red Pearl ,Auto Coupe (Parts car) -1990 11 Sec Eagle Talon Tsi AWD, (SOLD!) -1996 Hyundai Sonata (Given to me for FREE , due to broken timing belt,bent valves.. fixed it myself and its my new DD that gets over 25 mpg! -2004 Honda CBR 600RR (Candy blue, FOR SALE)
Follow Ups	AEM EMS and O2 Sensor Question - collegeboy 14:58:38 01/27/08 Re: AEM EMS and O2 Sensor Question - kickerzx 15:09:02 01/27/08 WB O2 sensors don't like heat, so you should not install - Dark Diver 17:03:53 01/27/08 I know that... - collegeboy 17:33:15 01/27/08 Plug the stock 02 sensor locations.. - Kong ZTT GT28RS MD 17:20:22 01/27/08 You did? And yes I got it shipped out again. - collegeboy 17:32:30 01/27/08 haha.. - Kong ZTT GT28RS MD 18:53:01 01/27/08 My SZ 3" TP's are angled down, have had to change my WB o2 - 550HPTT 19:21:48 01/27/08 I mean the tip (sensor part) - Kong ZTT GT28RS MD 19:30:36 01/27/08 Yes i was following that much lol, was just pointing out - 550HPTT 19:39:38 01/27/08 Im glad i only have one DP to worry about... - 1badz32 (MN) 20:33:38 01/27/08
Post a Followup	You cannot reply to this message because you are not logged in.