TwinTurbo.NET: Nissan 300ZX forum - What is not correct ?...
People Seeking Info
 
   


     
Subject What is not correct ?...
     
Posted by Z1rider on January 23, 2008 at 10:38 AM
  This message has been viewed 71 times.
     
In Reply To Not sure if that is completely correct posted by ChazZ on January 23, 2008 at 01:58 AM
     
Message ... I never said anything about fuel control. The rear sensors monitor oxygen in the exhaust as a result of the cat. convertors conversion of HC's, CO, etc. The frequency ratio needs to be much slower, and of a lower peak voltage, than the front O2 sensors. The MIL eliminators are a RC (resistor/capacitor) circuit which modifies this frequency. The MIL, and stored codes, will cause a failure of emmission testing.

With experience, comes age.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.