Subject	I hear you, but Woody was speaking from personal
Posted by	robo (sebring1970) on January 23, 2008 at 7:41 AM
	This message has been viewed 24 times.
In Reply To	Yup, that is pretty much exactly my question posted by Ashman2k2 on January 23, 2008 at 03:57 AM
Message	experience. He even had the same gauge as me, so I am going to ACE hardware to check it out. I don't think he would bullsh*t. "Straight-line acceleration is probably the first aspect of automotive performance that any intelligent driver gets bored with." Peter Gregg "We owe a lot to the dragsters. They always break something, figure out a way to beef up the part and the benefit trickles down." Robo "Not everything that can be counted counts. Not everything that counts can be counted." Einstein "And now my friend, the first-a rule of Italian driving, [Franco rips off his rear-view mirror and throws it out of the car] what's-a behind me is not important." Raul Julia, playing Franco Bertollini while driving a Ferrari Daytona in the movie Gumball Rally
Follow Ups	Where do you buy this part for the boost gauge?? - Ashman2k2 21:12:04 01/22/08 ace hardware or your local autozone (n/m) - spyhunterTT(nj) 21:18:27 01/22/08 Thanks, but how do i connect the nylon tube to the balance - Ashman2k2 21:29:39 01/22/08 tap into one of the vaccum lines w/ a T fitting (n/m) - apostrophe28 21:38:30 01/22/08 you get a T-fitting to tap into an existing vacuum line (n/m) - ZLover4Life 21:38:45 01/22/08 link inside.. - apostrophe28 21:40:10 01/22/08 Some folks use the included fitting directly in the plenum (n/m) - PCVI 22:38:48 01/22/08 Careful with that... Our pleneums use British Standard Pipe - Gordo 93TT Daytona 13:02:59 01/23/08 I just asked this same question - robo (sebring1970) 01:02:20 01/23/08 Yup, that is pretty much exactly my question - Ashman2k2 03:57:18 01/23/08 I hear you, but Woody was speaking from personal - robo (sebring1970) 07:41:08 01/23/08 Don't know about 4mm. - Woody75 (Denver) 08:22:33 01/23/08 Tru, I use the 1/4" brass barbs for my actuator to EBC lines (n/m) - Ashman2k2 17:11:52 01/23/08 My solution - pencerules 06:37:05 01/23/08
Post a Followup	You cannot reply to this message because you are not logged in.