Subject	Thanks!
Posted by	ENVYMYZ on January 17, 2008 at 11:37 PM
	This message has been viewed 35 times.
In Reply To	Re: specs for underhood measurements are in the FSM posted by tognot on January 17, 2008 at 11:35 PM
Message	How would I use the tape measure? I.E. am I measuring it from certain points, distances, off of engine components, etc.? The key to winning is knowing how to play the game. I am diabolically clever and can piss further than you can think...I always win.
Follow Ups	Hypothetical question. Forum vets may have an answer? - ENVYMYZ 23:15:02 01/17/08 Re: specs for underhood measurements are in the FSM - tognot 23:35:11 01/17/08 Thanks! - ENVYMYZ 23:37:59 01/17/08 Do you have a FSM? - Insomniac (VA) 23:59:30 01/17/08 Phil, if you need a FSM, Daryl's got mine... hit him up. (n/m) - ZLover4Life 00:42:17 01/18/08 Thanks for the offer Randy, but I happen to have - ENVYMYZ 01:59:15 01/18/08 I had a 90....was borrowed and lost. - awesom-o 07:49:22 01/18/08 Good suggestion! - Scotts94z32 09:36:54 01/18/08 and it's "straightened", not "straighted" (n/m) - NytWolf 10:38:02 01/18/08
Post a Followup	You cannot reply to this message because you are not logged in.