Subject	i just torqued down mine to a fidanza flywheel.
Posted by	apudapus on January 16, 2008 at 4:37 PM
	This message has been viewed 33 times.
In Reply To	DXD Clutch and Machined Flywheel Please Read posted by collegeboy on January 16, 2008 at 03:02 PM
Message	i preinstalled the PP to the flywheel off the car to test alignment. when i unbolted the PP, the threads and bolts looked fine. i finally torqued it down to 33 lbs. with locktite. *********************************
Follow Ups	DXD Clutch and Machined Flywheel Please Read - collegeboy 15:02:25 01/16/08 thanks for the heads up (n/m) - Atl300zxTT 15:08:20 01/16/08 Does RPS recommend 30lbs bolt torque? Reason I ask - Audioquest 15:37:54 01/16/08 I typically use the low end the spec when going into alum. - Bernie (NoVA) 15:44:47 01/16/08 So I should aim for 25 - 28 w/blue Lock-tite? (n/m) - Audioquest 15:50:32 01/16/08 Works fine for me. (n/m) - Bernie (NoVA) 15:53:14 01/16/08 Thanks (n/m) - Audioquest 16:07:47 01/16/08 If you are using the original holes in it then those have - collegeboy 17:50:08 01/16/08 It's the same w/ all aluminium flywheels - sparkie 16:00:53 01/16/08 i just torqued down mine to a fidanza flywheel. - apudapus 16:37:36 01/16/08 Doesn't the Fidenza have helicoils though? (n/m) - collegeboy 17:47:49 01/16/08 Fidanza does not have helicoils, Neither does my UR racing (n/m) - Spddracer 18:00:46 01/16/08 This is a new one. We have never had a problem with this - Spddracer 18:14:02 01/16/08
Post a Followup	You cannot reply to this message because you are not logged in.