Subject	if i could go into a time capsule, i would
Posted by	Alan(NJ) on January 14, 2008 at 9:49 PM
	This message has been viewed 41 times.
In Reply To	Re: Z32 Parts Time Capsule posted by 90AztecTT on January 14, 2008 at 09:27 PM
Message	wish the Z32 was released today (rather than the 350Z). with today's technology, but same body design Z is currently under renovation. pardon her appearance:
Follow Ups	Z32 Parts Time Capsule - dpjax 20:53:08 01/14/08 harness. (n/m) - Halo Z 20:56:13 01/14/08 I figure someone will make a replica whenever those are - ZEngineer 20:59:24 01/14/08 I've thought about doing it - ZLover4Life 21:10:02 01/14/08 charge 150 bucks and I'll buy one. (n/m) - BannonZ 21:11:13 01/14/08 I think the problem would be sourcing all of the connectors - aliaZ 21:34:12 01/14/08 yep. - Dallas DamonZ 23:02:56 01/14/08 If it came down to that - RSR 07:57:56 01/15/08 ? - Dallas DamonZ 08:34:24 01/15/08 ... - RSR 08:55:26 01/15/08 ... - RSR 08:59:01 01/15/08 yep. That's what scares me. (n/m) - Dallas DamonZ 09:55:03 01/15/08 when that happens... - ZLover4Life 21:06:29 01/15/08 "SR20 ricers" :finger: (n/m) - Halo Z 21:10:18 01/14/08 Redundancy Department of Repeatition (n/m) - Keaner 21:15:42 01/14/08 $10 says he takes exisiting harness sections and extends - Bernie (NoVA) 01:29:54 01/15/08 engine (n/m) - inf 20:58:10 01/14/08 Re: Z32 Parts Time Capsule - ZED2 20:59:44 01/14/08 wheel bearings (n/m) - 300zdett(houston tx) 21:08:05 01/14/08 Big 2nd! - monty31 21:11:06 01/14/08 I've been paranoid about my bearings going bad - ZEngineer 21:13:03 01/14/08 harness, wheel bearings, a proven good low miles motor - nemo1080 21:12:35 01/14/08 Un-cut Ti Keys. (n/m) - bstyleZ 21:23:35 01/14/08 60U filters. (n/m) - SkiFly01 21:25:07 01/14/08 Bernie already did that. (n/m) - BlackholeZ 21:42:22 01/14/08 Think it's a little late for that - Broke_as_**** 22:05:38 01/14/08 Real JSPEC Tail Lights (n/m) - 91300zxttkid 21:26:58 01/14/08 Re: Z32 Parts Time Capsule - 90AztecTT 21:27:21 01/14/08 if i could go into a time capsule, i would - Alan(NJ) 21:49:43 01/14/08 I wouldn't, because i couldn't be able to afford it. (n/m) - ali300zx 22:51:11 01/14/08 2nd (n/m) - nemo1080 01:34:04 01/15/08 Suede door panels and OEM "Z" floor mats - AbsolutZ (OH) 21:45:49 01/14/08 Just bought another set - TriniTT 00:20:51 01/15/08 wiring harness, interior trim,door jamb & t-top weatherstrip (n/m) - doug8867 21:53:30 01/14/08 Application specific electronics - Broke_as_**** 22:01:45 01/14/08 a flying Z, with 1.1 GW flux cap. (n/m) - vorpalZ 22:04:46 01/14/08 you are .11 GW short... - scottyfender 22:47:02 01/14/08 the most obvious. GASOLINE!!!!!!!!!!!!!!!!!!! - volcomstone550 22:09:08 01/14/08 I have a blank titanium key, a spare set of the "300ZX" - Only1Z 23:07:53 01/14/08 all moldings and weatherstripping, hood cowlings, - gt300zxtt 00:53:00 01/15/08 ooo, i like this answer. i will have the same. (n/m) - apudapus 02:21:10 01/15/08 Ditto. - Adam A. 08:56:11 01/15/08 Re: Z32 Parts Time Capsule - 90AztecTT 06:56:14 01/15/08
Post a Followup	You cannot reply to this message because you are not logged in.