Subject	lol, ya... That guy didnt even see what was wrong with that.
Posted by	Waco300zx(DFW) on January 13, 2008 at 7:12 PM
	This message has been viewed 35 times.
In Reply To	lets examine why it happens... posted by ni[X]it on January 13, 2008 at 06:29 PM
Message	jacking up his car by using the exhaust... SMART. ============================================== ===================Waco300zx==================== HREF="http://profile.myspace.com/index.cfm?fuseaction=user.viewprofile&friendID=32808956">Myspace
Follow Ups	cracked manifolds - nzryan 16:33:52 01/13/08 if you are a good welder they shouldnt crack anywhere - Antonio(AZ) 17:25:28 01/13/08 Even the GD inconel's cracked - nzryan 17:35:03 01/13/08 lets examine why it happens... - ni[X]it 18:29:05 01/13/08 but what would full race do? - aliaZ 18:48:06 01/13/08 Put a manual boost control on it... - Dallas DamonZ 19:14:18 01/13/08 lol, ya... That guy didnt even see what was wrong with that. - Waco300zx(DFW) 19:12:34 01/13/08 Dont forget the wide spectrum of intense vibration... - CaliguyPurdue (redesigning) 19:16:44 01/13/08 The GD inconels are fully supported at the flange - AZHeat 20:08:51 01/13/08 good points Nixit (n/m) - nzryan 21:05:20 01/13/08 not really - aliaZ 18:46:41 01/13/08 all might full race wouldnt use improper material - Antonio(AZ) 23:47:56 01/13/08 but I thought you said... - aliaZ 08:23:34 01/14/08 agreed. tubular mani's are just gonna crack. - nemo1080 16:02:48 01/14/08 Unless it is tubular cast then they would be - AZHeat 20:52:14 01/14/08 right - aliaZ 21:41:39 01/14/08 No welder needed, they are cast in a foundry. (n/m) - AZHeat 22:51:56 01/14/08 wow I had no idea cast iron was cast in a foundry (n/m) - aliaZ 07:39:53 01/15/08 And you are suppose to be an engineer? (n/m) - AZHeat 18:37:35 01/15/08 My apologies. - aliaZ 21:10:20 01/15/08 My BS meter just pegged. (n/m) - RSR 19:06:38 01/13/08 What material, thickness etc etc are you going to use? (n/m) - 550HPTT 17:29:57 01/13/08 Plate too? and Rod? And Temper? And Gas? - ni[X]it 18:30:16 01/13/08 My GReddy cracked every where possible. (n/m) - Carp (Show & Go) 19:25:04 01/13/08 so it cracked even on a unmachined/unwelded area? (n/m) - nzryan 21:06:27 01/13/08
Post a Followup	You cannot reply to this message because you are not logged in.