Subject	Need to replace fuel components...
Posted by	tlequeux on January 04, 2008 at 9:55 PM
	This message has been viewed 99 times.
Message	Getting the fuel smell this year in this cold weather. I've decided to go ahead and replace all the common fuel components. My question is, should I just get all the parts from courtesy or better of with someone on the boards here? From what I can tell I will need the following: Fuel Pressure Regulator Fuel Pressure Damper Fuel Hose ( 15 inches ) Protected Fuel Hose Fuel Filter Anything else?
Follow Ups	Need to replace fuel components... - tlequeux 21:55:46 01/04/08 conceptzperformance (n/m) - volcomstone550 21:56:33 01/04/08 Any forum sponsor. (n/m) - ali300zx 22:04:01 01/04/08 why not just check/tighten clamps as necessary? - LJZTT 22:06:34 01/04/08 2nd. Mine was underneath the throttle cover. - Waco300zx(DFW) 22:10:48 01/04/08 the two stacked above& below each other at the rear of the - LJZTT 22:12:08 01/04/08 Seems like I angled the clamps so I could get to them - Waco300zx(DFW) 22:15:39 01/04/08 Yea, this happened to me the other morning - 300ZMang 02:12:24 01/05/08 Because I can't find a leak anywhere - tlequeux 22:17:51 01/04/08 Then it's under the plenum or down by the steering rod. (n/m) - Bernie (NoVA) 22:19:44 01/04/08 Plenum smells of fuel pretty badly - tlequeux 22:30:25 01/04/08 here ---> - robo (sebring1970) 22:39:18 01/04/08 If they have never been replaced they need to be. - DVDBURN (MD) 22:49:47 01/04/08 2nd (n/m) - Spddracer 22:56:42 01/04/08 *can be - LJZTT 15:19:33 01/05/08 A few things about this job --- If you are not planning to - jzack 14:50:57 01/05/08
Post a Followup	You cannot reply to this message because you are not logged in.