Subject	I had a Central Pneumatics air chisel go out
Posted by	fourZero on December 04, 2007 at 12:08 AM
	This message has been viewed 36 times.
In Reply To	mine is still working great after 5 yrs of use (n/m) posted by Guapo on December 03, 2007 at 07:50 PM
Message	after only 10 minutes. I no longer buy air tools from Harbor Freight. I did find some killer aluminum jack stands though, the place is not totally worthless. Kind of sad that everything in there is Chi-comm produced. "Political correctness is a doctrine fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end." "It must suck for you to be the most retarded than everyone else here." -AzHeat 09:30:20 09/10/04 "So I nailed it, took off like an F18 from carrier. Of course the chase begained." -Tim_N/A 10:27:15 04/07/03 "Ps, I ate a real chocolate jesus today. it was kick ass. it was about 3" tall and solid chocolate. I was in heaven." - niXit 10:53:48 10/02/02
Follow Ups	Will a dremel tool with cutoff wheel cut thru the AIV pipe - doug8867 18:53:43 12/03/07 Dude, die grinders are like $14 at harbor freight. - Spddracer 18:59:16 12/03/07 Don't waste your money - fourZero 19:45:32 12/03/07 mine is still working great after 5 yrs of use (n/m) - Guapo 19:50:18 12/03/07 2nd (n/m) - Spddracer 20:16:24 12/03/07 I had a Central Pneumatics air chisel go out - fourZero 00:08:26 12/04/07 Never had a problem with their air tools. Their dremel - AZHeat 13:33:17 12/04/07 Can't beat the Wal-mart warranty (n/m) - SkiFly01 21:08:21 12/03/07 But I've already got the Dremel. :-) (n/m) - doug8867 22:02:52 12/03/07 i believe this is the best way. - apudapus 01:10:53 12/04/07 You'll probably go through a bunch of disks - BlackholeZ 19:00:31 12/03/07 Easily. I cut mine with a dremel. The reinforced - ShakaShaun(Denver) 19:02:15 12/03/07 2nd. I just switched to the reinforced ones - Ashman2k2 21:20:26 12/03/07 You'll prob. want a impact wrench to take those out... (n/m) - Bernie (NoVA) 19:02:58 12/03/07 Serious question... - CaliguyPurdue (redesigning) 20:05:30 12/03/07 Deep impact - I meant after cutting the tube off. (n/m) - Bernie (NoVA) 20:08:22 12/03/07 Yeah, good call. I've got one. (n/m) - doug8867 21:53:00 12/03/07 Re: Will a dremel tool with cutoff wheel cut thru the AIV pi - yeehonda 19:11:17 12/03/07 if you collapse it, then bend it a few times, it'll tear off (n/m) - ZEngineer 20:47:07 12/03/07 Thanks guys. (n/m) - doug8867 22:01:06 12/03/07
Post a Followup	You cannot reply to this message because you are not logged in.