Subject	Re: Will a dremel tool with cutoff wheel cut thru the AIV pi
Posted by	yeehonda on December 03, 2007 at 7:11 PM
	This message has been viewed 41 times.
In Reply To	Will a dremel tool with cutoff wheel cut thru the AIV pipe posted by doug8867 on December 03, 2007 at 06:53 PM
Message	I cut both of my pre-cats which are cast iron with a reinforced cut-off wheel and a dremel. I think you should be ok cutting steel.
Follow Ups	Will a dremel tool with cutoff wheel cut thru the AIV pipe - doug8867 18:53:43 12/03/07 Dude, die grinders are like $14 at harbor freight. - Spddracer 18:59:16 12/03/07 Don't waste your money - fourZero 19:45:32 12/03/07 mine is still working great after 5 yrs of use (n/m) - Guapo 19:50:18 12/03/07 2nd (n/m) - Spddracer 20:16:24 12/03/07 I had a Central Pneumatics air chisel go out - fourZero 00:08:26 12/04/07 Never had a problem with their air tools. Their dremel - AZHeat 13:33:17 12/04/07 Can't beat the Wal-mart warranty (n/m) - SkiFly01 21:08:21 12/03/07 But I've already got the Dremel. :-) (n/m) - doug8867 22:02:52 12/03/07 i believe this is the best way. - apudapus 01:10:53 12/04/07 You'll probably go through a bunch of disks - BlackholeZ 19:00:31 12/03/07 Easily. I cut mine with a dremel. The reinforced - ShakaShaun(Denver) 19:02:15 12/03/07 2nd. I just switched to the reinforced ones - Ashman2k2 21:20:26 12/03/07 You'll prob. want a impact wrench to take those out... (n/m) - Bernie (NoVA) 19:02:58 12/03/07 Serious question... - CaliguyPurdue (redesigning) 20:05:30 12/03/07 Deep impact - I meant after cutting the tube off. (n/m) - Bernie (NoVA) 20:08:22 12/03/07 Yeah, good call. I've got one. (n/m) - doug8867 21:53:00 12/03/07 Re: Will a dremel tool with cutoff wheel cut thru the AIV pi - yeehonda 19:11:17 12/03/07 if you collapse it, then bend it a few times, it'll tear off (n/m) - ZEngineer 20:47:07 12/03/07 Thanks guys. (n/m) - doug8867 22:01:06 12/03/07
Post a Followup	You cannot reply to this message because you are not logged in.