Subject	My two cents. Save the driveshaft "upgrade" for if and when
Posted by	robo (sebring1970) on December 02, 2007 at 9:31 AM
	This message has been viewed 54 times.
In Reply To	Anyone bought an RDZ 1-piece driveshaft? Vs. Z1's? posted by SaucyTabasco on December 02, 2007 at 03:37 AM
Message	your stock shaft fails. Then it is a cost effective replacement, and the labor is just as doable down the road.
Follow Ups	Anyone bought an RDZ 1-piece driveshaft? Vs. Z1's? - SaucyTabasco 03:37:32 12/02/07 Get the Z1 platinum - collegeboy 04:03:37 12/02/07 Ha... Finally found out what kind the last one i had was - 550HPTT 07:17:51 12/02/07 My two cents. Save the driveshaft "upgrade" for if and when - robo (sebring1970) 09:31:14 12/02/07 2nd - aliaZ 09:49:47 12/02/07 would extra damage occur to other parts when the DS lets go? (n/m) - Max865(ATL) 13:33:49 12/02/07 I'm talking about a routine stock driveshaft failure from - robo (sebring1970) 14:37:36 12/02/07 Thanks for the advice, but I am at 114K and my NA's - SaucyTabasco 15:26:20 12/02/07 It will tear up the rear trans seal and front diff seal - Broke_as_**** 18:39:11 12/02/07 thanks (n/m) - Max865(ATL) 21:37:06 12/02/07 probably not, mine just started clunking in reverse (n/m) - fourZero 23:16:41 12/02/07 Actually it does. - Broke_as_**** 00:54:36 12/03/07 it must depend on the severity of the failure - fourZero 01:51:40 12/03/07
Post a Followup	You cannot reply to this message because you are not logged in.