Subject	i've done it with the hf jack a few times now
Posted by	spyhunterTT(nj) on November 21, 2007 at 6:08 PM
	This message has been viewed 202 times.
In Reply To	Subframe removal. and harbor freight FTW. posted by volcomstone550 on November 21, 2007 at 04:15 PM
Message	good luck with the solids. Putting them in the freezer didn't work too well for me. If you run into that, buy a case of compressed air and use that to freeze the solids, grease them up and hammer then in Alex
Follow Ups	Subframe removal. and harbor freight FTW. - volcomstone550 16:15:11 11/21/07 yes, i'd for sure purchase a subframe with all the bushings - inf 16:23:31 11/21/07 2nd, prolly - BlackholeZ 16:34:16 11/21/07 Re: Subframe removal. and harbor freight FTW. - merlin3 16:39:00 11/21/07 weird, my real name is Ralph Merlin Smith III..merlin3 (n/m) - volcomstone550 00:12:21 11/22/07 don't worry so much about replacing the bushing - ZEngineer 16:58:28 11/21/07 Getting the bushings out was pretty straight forward - Ashman2k2 17:01:15 11/21/07 huh? Getting the new bushings in was cake compared to - Spee 22:37:35 11/21/07 Re: Don't put it back together unless... - Z pearl 17:33:34 11/21/07 can i take the brakes off without cracking lines open? (n/m) - 300zx16 17:47:20 11/21/07 yes, just unbolt the calipers (n/m) - aliaZ 17:54:24 11/21/07 how much better did it feel than before? (n/m) - inf 17:50:05 11/21/07 OCD much? - Spee 22:21:15 11/21/07 Re: OCD much? - MGH (Z pearl) 07:57:41 11/22/07 i've done it with the hf jack a few times now - spyhunterTT(nj) 18:08:05 11/21/07 memories.... - LJZTT 18:25:28 11/21/07 Mine balanced on a regular floorjack also. - Gordo 93TT Daytona 19:45:30 11/21/07 is that a joke? (n/m) - inf 19:47:22 11/21/07 Nope, Gordo doesn't joke around about that stuff. (n/m) - Barry'z (NJ) 20:04:28 11/21/07 yep, had he been joking it would been more like.... - LJZTT 23:31:31 11/21/07 i kept reading posts about how dangerous it was by yourself - volcomstone550 00:14:07 11/22/07 NICE Z man! - Kong ZTT GT28RS MD 19:25:41 11/21/07 enjoy - Spee 22:19:44 11/21/07 i saw your post about your full aluminum bushing setup - volcomstone550 00:15:44 11/22/07 Looks like fun. I probably will go with the same settup, - dregos 03:20:27 11/22/07
Post a Followup	You cannot reply to this message because you are not logged in.