Subject	Thanks
Posted by	Nis300owner on November 16, 2007 at 1:41 PM
	This message has been viewed 37 times.
In Reply To	LOL, just what I expected to see (n/m) posted by na300zx (OH) on November 16, 2007 at 01:35 PM
Message	Mainly was just asking what the chances were that I put the motor back in and the sensor go bad. Car has 56k miles so was thinking it would be safe to reuse just making sure no one else had a bad experiance with this situation
Follow Ups	knock sensor (detnation) - Nis300owner 13:11:42 11/16/07 sensor rarely goes out, mainly it's the - Halo Z 13:24:11 11/16/07 the sensor itself is clean. Am I good to reuse it? (n/m) - Nis300owner 13:27:42 11/16/07 Re: the sensor itself is clean. Am I good to reuse it? - Halo Z 13:31:10 11/16/07 LOL, just what I expected to see (n/m) - na300zx (OH) 13:35:42 11/16/07 Thanks - Nis300owner 13:41:05 11/16/07 Re: the sensor itself is clean. Am I good to reuse it? - IB 13:43:23 11/16/07 Thanks for the advice that helped a lot (n/m) - Nis300owner 13:44:59 11/16/07 replace it, too much hassel to pull engine twice (n/m) - WildBill 16:46:06 11/16/07 Who sells these for $55.00? I need one (n/m) - ae300z 17:38:00 11/16/07 GENUINEPARTS4LESS through ebay, $55 shiped # 22060-30P00 - Fast300 03:40:51 11/17/07 Mine cracked from age, they are too cheap not to replace (n/m) - Fast300 03:47:23 11/17/07 Buy a new one. Too hard to replace later. (n/m) - Spddracer 21:36:08 11/16/07
Post a Followup	You cannot reply to this message because you are not logged in.