Subject	knock sensor (detnation)
Posted by	Nis300owner on November 16, 2007 at 1:11 PM
	This message has been viewed 81 times.
Message	I pulled my motor to change harnesses and things. My knock sensor harness was basically gone and cracked. Bout new harness and my question is how easily does the sensor go out? Am i safe to just replace the harness. Thanks Guys!
Follow Ups	knock sensor (detnation) - Nis300owner 13:11:42 11/16/07 sensor rarely goes out, mainly it's the - Halo Z 13:24:11 11/16/07 the sensor itself is clean. Am I good to reuse it? (n/m) - Nis300owner 13:27:42 11/16/07 Re: the sensor itself is clean. Am I good to reuse it? - Halo Z 13:31:10 11/16/07 LOL, just what I expected to see (n/m) - na300zx (OH) 13:35:42 11/16/07 Thanks - Nis300owner 13:41:05 11/16/07 Re: the sensor itself is clean. Am I good to reuse it? - IB 13:43:23 11/16/07 Thanks for the advice that helped a lot (n/m) - Nis300owner 13:44:59 11/16/07 replace it, too much hassel to pull engine twice (n/m) - WildBill 16:46:06 11/16/07 Who sells these for $55.00? I need one (n/m) - ae300z 17:38:00 11/16/07 GENUINEPARTS4LESS through ebay, $55 shiped # 22060-30P00 - Fast300 03:40:51 11/17/07 Mine cracked from age, they are too cheap not to replace (n/m) - Fast300 03:47:23 11/17/07 Buy a new one. Too hard to replace later. (n/m) - Spddracer 21:36:08 11/16/07
Post a Followup	You cannot reply to this message because you are not logged in.