Subject	Re: They're working with me
Posted by	tech@EPR on November 14, 2007 at 7:20 PM
	This message has been viewed 48 times.
In Reply To	They're working with me posted by fourZero on November 14, 2007 at 01:42 PM
Message	Do you have any flow numbers from the Z1 cylinder heads and ones that this other shop had done for you? Do you have anymore pics of the Z1 heads at all and yours after the shop remachined/ported yours?
Follow Ups	Oversize main bearing question - fourZero 18:12:50 11/13/07 Damon.. Ash.. Kyle.. Greg.. ?? - fourZero 22:48:03 11/13/07 Here is what I would do in your case >>>> - Ash's Z 19:55:09 11/14/07 $20 block, $50 crank, i am in business. - fourZero 20:18:57 11/14/07 It was probably scored/damaged from a previous - NAZTTy 07:50:34 11/15/07 the "new" old block and crank are being inspected @ the shop - fourZero 12:40:46 11/15/07 This post is worthless without pics :) (n/m) - AZHeat 00:10:46 11/14/07 they're really not nearly as exciting as the first time - fourZero 01:13:04 11/14/07 Shop at fault? (n/m) - BigTDogg (MA) 12:39:40 11/14/07 They're working with me - fourZero 13:42:25 11/14/07 Re: They're working with me - tech@EPR 19:20:07 11/14/07 Did you click on the link? There are tons of pics. (n/m) - fourZero 22:35:17 11/14/07 My $0.02 - DAYTONAZ 15:58:25 11/14/07 More on the crank - DAYTONAZ 16:26:23 11/14/07 thanks for the advice - fourZero 16:43:09 11/14/07 Re: thanks for the advice - DAYTONAZ 19:03:47 11/14/07 Re: thanks for the advice - DAYTONAZ 19:11:51 11/14/07 again, thank you - fourZero 20:10:44 11/14/07 Good luck, it just pays to ask questions and be informed (n/m) - DAYTONAZ 20:17:16 11/14/07
Post a Followup	You cannot reply to this message because you are not logged in.