Subject	Damon.. Ash.. Kyle.. Greg.. ??
Posted by	fourZero on November 13, 2007 at 10:48 PM
	This message has been viewed 101 times.
In Reply To	Oversize main bearing question posted by fourZero on November 13, 2007 at 06:12 PM
Message	I found this old post by Damon, but little else about the oversize bearings. Can someone confirm the part #? La-Z-Link "It must suck for you to be the most retarded than everyone else here." -AzHeat 09:30:20 09/10/04 "So I nailed it, took off like an F18 from carrier. Of course the chase begained." -Tim_N/A 10:27:15 04/07/03 "Ps, I ate a real chocolate jesus today. it was kick ass. it was about 3" tall and solid chocolate. I was in heaven." - niXit 10:53:48 10/02/02
Follow Ups	Oversize main bearing question - fourZero 18:12:50 11/13/07 Damon.. Ash.. Kyle.. Greg.. ?? - fourZero 22:48:03 11/13/07 Here is what I would do in your case >>>> - Ash's Z 19:55:09 11/14/07 $20 block, $50 crank, i am in business. - fourZero 20:18:57 11/14/07 It was probably scored/damaged from a previous - NAZTTy 07:50:34 11/15/07 the "new" old block and crank are being inspected @ the shop - fourZero 12:40:46 11/15/07 This post is worthless without pics :) (n/m) - AZHeat 00:10:46 11/14/07 they're really not nearly as exciting as the first time - fourZero 01:13:04 11/14/07 Shop at fault? (n/m) - BigTDogg (MA) 12:39:40 11/14/07 They're working with me - fourZero 13:42:25 11/14/07 Re: They're working with me - tech@EPR 19:20:07 11/14/07 Did you click on the link? There are tons of pics. (n/m) - fourZero 22:35:17 11/14/07 My $0.02 - DAYTONAZ 15:58:25 11/14/07 More on the crank - DAYTONAZ 16:26:23 11/14/07 thanks for the advice - fourZero 16:43:09 11/14/07 Re: thanks for the advice - DAYTONAZ 19:03:47 11/14/07 Re: thanks for the advice - DAYTONAZ 19:11:51 11/14/07 again, thank you - fourZero 20:10:44 11/14/07 Good luck, it just pays to ask questions and be informed (n/m) - DAYTONAZ 20:17:16 11/14/07
Post a Followup	You cannot reply to this message because you are not logged in.