Subject	No, but there is a small opening >>>
Posted by	KaZ (Injured List) on May 30, 2001 at 10:04 PM
	This message has been viewed 18 times.
In Reply To	Lazyass question. Before I put the Z on jack stands, Is>>> posted by WOTZ on May 30, 2001 at 09:53 PM
Message	At the very bottom of the tranny where it meets with the motor bell housing. If you're leaking fluid out of there, then either your transmission seal is gone, or your rear main seal is gone. You may be able to pull the two bell housing plates off and see if you can feel up behind the flywheel to see if its leaking, but as I remember, there isn't very much room in there to feel around! Hope this helps. Later, KaZ ICQ - 22589000 / IM - KaZsMiR / E-mail - casimijg@jmu.edu
Follow Ups	Lazyass question. Before I put the Z on jack stands, Is>>> - WOTZ 21:53:56 05/30/01 No, but there is a small opening >>> - KaZ (Injured List) 22:04:09 05/30/01 Yes, Thank you KaZ. I am not that concerned with it>>> - WOTZ 22:21:52 05/30/01 I don't type all that fast, but >>> - KaZ (Injured List) 22:36:16 05/30/01
Post a Followup	You cannot reply to this message because you are not logged in.