Subject	Don't know about MM's but HPS's do suck compared to
Posted by	zboost(NoVA) on November 02, 2007 at 5:36 PM
	This message has been viewed 64 times.
In Reply To	Hawk HPS pads are sucks. posted by ENVYMYZ on November 02, 2007 at 05:30 PM
Message	my axxis ultimates. As soon as I get my car back, that's my next project: get rid of those shitty pads. Besides fade they basically have no initial bite and really don't STOP the car anywhere near like my ultimates did. BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :) (VGTT set-up) stock turbos/injectors "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	Hawk HPS pads are sucks. - ENVYMYZ 17:30:01 11/02/07 Don't know about MM's but HPS's do suck compared to - zboost(NoVA) 17:36:15 11/02/07 oops, looks like i got owned... (n/m) - Keaner 17:39:25 11/02/07 I think you're the first one I've heard dislike them... - Keaner 17:39:02 11/02/07 Brakes were bled 4 times at the time of install. - ENVYMYZ 17:45:39 11/02/07 Yeah, pretty much - Broke_as_**** 17:51:37 11/02/07 The cake is a lie... (n/m) - johnnysombrero 21:50:29 11/02/07 all I know is my MM's are noisy... - inf 17:45:31 11/02/07 My MM's have been noisy as hell- - Keaner 17:54:10 11/02/07 user error (n/m) - Guapo 17:47:27 11/02/07 "Hawk HPS pads are sucks." ? (n/m) - Spongerider :) 17:56:19 11/02/07 Poor Grammar== Wicked Cool (n/m) - Keaner 17:57:41 11/02/07 Engrish.com (n/m) - Z_Cherub 20:24:52 11/02/07 hmmm i've always run MMers and slotted. - Halo Z 18:06:51 11/02/07 LOL, vatozone.....awesome - LJZTT 18:35:39 11/02/07 How do you fade brakes, on the street, in an NA? - ni[X]it 18:13:44 11/02/07 You obviously don't have 'fun' streets around you (n/m) - Keaner 18:15:27 11/02/07 Not hard - Twisties and repeat :P - bstyleZ 18:59:51 11/02/07 Amen (n/m) - Keaner 19:48:09 11/02/07 I've run tail of the dragon - ben7021 21:21:33 11/02/07 ^^^ What Nix said. (n/m) - Inzane 13:57:47 11/03/07 I agree. - ZCulture 18:28:46 11/02/07 Might be... - golden_1 18:46:12 11/02/07 Shit, I just sold my brand new MM before installing them... - Dark Diver 18:33:35 11/02/07 They are a good quiet low dusting street pad - maglito 18:38:15 11/02/07 Funny, I switched to Hawk HPS pads from my MM - AbsolutZ (OH) 20:31:50 11/02/07 Maybe it's the slotted rotors? - SactoTodd 20:39:33 11/02/07 Fair enough, but I doubt it's the rotors. (n/m) - ENVYMYZ 09:57:33 11/03/07 I have the same setup, and they are the best pad I've used. (n/m) - ZiNnYc 21:15:42 11/02/07 From speaking with Greg I believe it's the brembo rotors and - ShakaShaun(Denver) 21:27:06 11/02/07 So what did he recommend you use with those rotors? (n/m) - ENVYMYZ 09:58:11 11/03/07 I would think problems with the rotors would be evident... - thejoneZ (Sacto, CA) 21:29:25 11/02/07 Funny, i've only had good luck with Hawk HPS pads, do this > - Coz@CZP 23:19:37 11/02/07 Quite possible. I did buy these pads from Ultimate Z after - ENVYMYZ 10:00:12 11/03/07 I've had the Hawk HPS with Skyline rotors 4 yrs - RHulme 23:58:14 11/02/07 My HPS > than MM (w/slotted rotors) - RedZ 00:37:19 11/03/07 Re: Hawk HPS pads are sucks. - Slider 08:26:58 11/03/07 Axxis MM or ultimate ? (n/m) - Dark Diver 09:35:25 11/03/07 Those were Axxis Ultimate, a semi-track pad (n/m) - Guapo 09:58:15 11/03/07 Why the stoptech's if you don't go to the track? (n/m) - TTFairladyZ 18:55:04 11/03/07 Re: Why the stoptech's if you don't go to the track? - Slider 11:23:01 11/04/07 I did'nt care for the HPS pads either...they did'nt - racer2fst 08:32:46 11/03/07 Same results here. The PBRs/MMs have better initial - Yoshi 17:00:13 11/03/07 3rd. (n/m) - BradZ (FL) 00:10:52 11/04/07 They got me through the Dragon with no complaints... (n/m) - TT XTZ 10:48:34 11/03/07 false (n/m) - Spee 13:58:08 11/03/07 Sounds like the pads are glazed - kuah@splparts.com 14:47:33 11/03/07 What do the pads look like if this happens? Any fix? (n/m) - pearl5 15:41:31 11/03/07 Re: What do the pads look like if this happens? Any fix? (n/ - kuah@splparts.com 15:56:27 11/03/07 BTW, bed-in procedure for Hawk street compounds - kuah@splparts.com 16:01:07 11/03/07 Yep, proper bedding is everything - SeedyROM 16:07:00 11/03/07 Thanks for the info Kuah. Ill yank em and have a look see. (n/m) - ENVYMYZ 17:23:45 11/03/07 I found the HPS's and slotted/drilled rotors much better >> - my91z 15:37:16 11/03/07 2nd. (n/m) - ThunderZ 17:08:07 11/03/07
Post a Followup	You cannot reply to this message because you are not logged in.