Subject	Oops. I had not actually paid attention to that. Good call. (n/m)
Posted by	Ghozt on October 16, 2007 at 7:26 AM
	This message has been viewed 35 times.
In Reply To	notice it is just the housing, not the whole turbo assembly. (n/m) posted by Spee on October 15, 2007 at 09:47 PM
Message
Follow Ups	EGTs in the turbos. - AZHeat 21:22:08 10/15/07 Why not put it in the down-pipe? (n/m) - Barry'z (NJ) 21:26:26 10/15/07 fuzzy readings after going through the turbo. (n/m) - Halo Z 21:31:17 10/15/07 Thanks. (n/m) - Barry'z (NJ) 21:44:56 10/15/07 Here is link as to why - AZHeat 21:39:11 10/15/07 Danke. (n/m) - Barry'z (NJ) 21:44:12 10/15/07 There is a large temperature drop across turbines. - Inzane 10:30:55 10/16/07 Looks great. I would be to chicken, afraid of getting metal - Ghozt 21:41:14 10/15/07 notice it is just the housing, not the whole turbo assembly. (n/m) - Spee 21:47:01 10/15/07 Oops. I had not actually paid attention to that. Good call. (n/m) - Ghozt 07:26:53 10/16/07 nice paperweight. (n/m) - Spee 21:46:00 10/15/07 does it need to stick in that far? - aliaZ 22:07:02 10/15/07 sig quote (n/m) - vorpalZ 22:20:26 10/15/07 Actualy it screws in farther. It was only a test fit - AZHeat 22:35:24 10/15/07 Isn't it an adjustable-depth probe? - 300zx90 (CO) 18:28:45 10/16/07 from what I understand, yes, you'd want it good-n-deep. (n/m) - ni[X]it 21:13:34 10/16/07 wonder how the flow will be disrupted (n/m) - inf 22:32:37 10/15/07 No more or less than 02 sensor. (n/m) - AZHeat 22:37:39 10/15/07 hope it doesn't break off (n/m) - spyhunterTT(nj) 05:55:56 10/16/07 Not sure if you did, but put the holes in the same spot - The Devils Z 09:37:28 10/16/07 Re: EGTs in the turbos. - ni[X]it 21:09:13 10/16/07
Post a Followup	You cannot reply to this message because you are not logged in.