Subject	Wondered about this myself; the push/pull gauge
Posted by	olyar15 on October 15, 2007 at 3:39 PM
	This message has been viewed 102 times.
In Reply To	Pull gauge for timing belt posted by BlackholeZ on October 15, 2007 at 09:46 AM
Message	is mentioned several times in the FSM for setting the deflection of the various belts. For the accessory belts I have just gone by eye, but the method described in the FSM seems to be quite specific on the amount of force to measure deflection of the timing belt. Charles Carbon Black '95 TT Carbon Black '03 BMW M5 '02 Honda CR-V dogmobile
Follow Ups	Pull gauge for timing belt - BlackholeZ 09:46:35 10/15/07 autozone maybe (n/m) - 90tt2+2z (WI) 10:40:25 10/15/07 whatever it is - turbomaniac 11:27:38 10/15/07 2nd. (n/m) - BradZ (FL) 12:17:10 10/15/07 3rd (n/m) - Madhatter10-6 12:21:13 10/15/07 dont think u will need one (n/m) - Drk93TT 12:17:08 10/15/07 don't need one, hence Auto Tensioner (n/m) - BigTDogg (MA) 12:24:28 10/15/07 You can try a hand held scale used for weighting - AZHeat 12:50:14 10/15/07 Something everyone should have in their garage... (n/m) - BigTDogg (MA) 12:56:05 10/15/07 2nd (n/m) - Drk93TT 13:19:40 10/15/07 Re: Something everyone should have in their garage... - AZHeat 16:54:14 10/15/07 for doing what to fish? (n/m) - Spee 19:41:20 10/15/07 Never used one. (n/m) - YugoBernie (NoVA) 13:49:03 10/15/07 2nd. (n/m) - Woody75 (Denver) 14:05:45 10/15/07 So you just check the tension by hand? any pointers? (n/m) - BlackholeZ 16:28:37 10/15/07 Set tensioner gap to ~5MM, turn motor by hand, check again. (n/m) - YugoBernie (NoVA) 17:00:37 10/15/07 4 or 5mm allen wrench works well for that task. (n/m) - Guapo 17:11:19 10/15/07 Indeed. (n/m) - YugoBernie (NoVA) 17:25:32 10/15/07 So you want to end up w/ 4-5mm gap after turning? - BlackholeZ 23:13:17 10/15/07 Yes. (n/m) - YugoBernie (NoVA) 12:34:31 10/16/07 Wondered about this myself; the push/pull gauge - olyar15 15:39:35 10/15/07 Use a hand held fish scale. It is what fisher man - AZHeat 16:54:00 10/15/07 *weigh (n/m) - ZiNnYc 21:29:40 10/15/07
Post a Followup	You cannot reply to this message because you are not logged in.