Subject	Our cranks are nitrided
Posted by	BlackholeZ on October 13, 2007 at 12:25 PM
	This message has been viewed 95 times.
In Reply To	Did you have a new wiring harness? posted by jcieslik on October 12, 2007 at 09:42 PM
Message	It is a process that hardens the surface of the crank to be much more durable. Regrinding will take that off. You can have the crank re-nitrided, but that's pricey. _____________Sig_____________ Live, breathe, eat, sleep Z "When Chuck Norris was denied an Egg McMuffin at McDonald's because it was 10:35, he roundhouse kicked the store so hard it became a Wendy's." "When the boogey man goes to bed at night, he checks the closet for Chuck Norris." "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "bashcomesinandpostallhiswishdomonthisin85432pagesofBS (n/m)" - Halo Z "Z32 it will get you for life" - Smitytec "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne
Follow Ups	Crank regrind issues on motor builds - The Devils Z 21:11:19 10/12/07 Did you have a new wiring harness? - jcieslik 21:42:04 10/12/07 new wiring harness -- yes --detonation on one cylinder - The Devils Z 22:05:05 10/12/07 Our cranks are nitrided - BlackholeZ 12:25:55 10/13/07 I am assuming that it is only if the original crank - olyar15 21:51:37 10/12/07 Nissan spent alot of money and R+D to design the OEM - The Devils Z 06:17:58 10/13/07 You should really consider getting Greg’s' block - Octavian 21:55:47 10/12/07 So far they've been doing well - SeedyROM 22:00:23 10/12/07 I don't know much about Greg / SZ engine process ..I - The Devils Z 22:02:51 10/12/07 last time I checked he had three short blocks laying in - Octavian 22:05:58 10/12/07 yeah those are long gone now (n/m) - Seb (specialty-Z) 00:52:29 10/13/07 I know where one of them is sitting ;) (n/m) - spotz 01:41:12 10/13/07 Ouch :/ (n/m) - SeedyROM 21:59:07 10/12/07 ouch man...SGP....the suck.... sorry man. - spotz 22:18:57 10/12/07 Thanks for the info (n/m) - IB 22:49:04 10/12/07 Re: Crank regrind issues on motor builds - txq45 08:31:43 10/13/07 From everything I've heard/read it seems like once a bearing - Crim 09:19:57 10/13/07 Thanks for sharing. (n/m) - Boosted1 10:24:04 10/13/07 Although I can't see the pics at work I have a good - DAYTONAZ 14:48:03 10/13/07 Re: Crank regrind issues on motor builds - Brad@ZSolutions 15:44:15 10/13/07
Post a Followup	You cannot reply to this message because you are not logged in.