Subject	still working on that
Posted by	gt300zxtt on October 10, 2007 at 10:50 AM
	This message has been viewed 33 times.
In Reply To	how do those 600r's fit? (n/m) posted by Alan(NJ) on October 10, 2007 at 08:56 AM
Message	i have had to make a few modifications.....like grinding off the heat shield mount. compressor inlet pipe on one side interfered with the actuator, so i had to make some adjustments there.
Follow Ups	i have been powdercoating some this past week or two - gt300zxtt 22:21:56 10/09/07 i would eat off that exhaust sheild! - nemo1080 22:26:33 10/09/07 Re: i have been powdercoating some this past week or two - buzzfast 00:08:05 10/10/07 looks great, but I'm curious how well the powdercoating will - Furb (NoVa) 07:17:58 10/10/07 almost same as jet hot coatings - gt300zxtt 10:41:11 10/10/07 cool, thanks for the info. Wasn't aware their was any high - Furb (NoVa) 11:42:40 10/10/07 cure at 500 deg F - gt300zxtt 16:59:26 10/10/07 wow dude, that'll look better than brand new! - BlackholeZ 07:41:20 10/10/07 schweet! (n/m) - Barry'z (NJ) 08:23:44 10/10/07 how do those 600r's fit? (n/m) - Alan(NJ) 08:56:54 10/10/07 still working on that - gt300zxtt 10:50:19 10/10/07 nice ! (n/m) - The Devils Z 09:15:57 10/10/07 Did you buy your own equipment or what? (n/m) - J-Mart 11:05:13 10/10/07 yes - gt300zxtt 11:38:08 10/10/07 Eastwood? (n/m) - Gordo 93TT Daytona 14:26:46 10/10/07 yes - gt300zxtt 15:45:52 10/10/07 read my profile :] (n/m) - gt300zxtt 15:46:48 10/10/07 Eastwood is a great source of restoration materials and - Gordo 93TT Daytona 21:44:31 10/10/07
Post a Followup	You cannot reply to this message because you are not logged in.