Subject	Pulling motor
Posted by	Nis300owner on October 09, 2007 at 4:29 PM
	This message has been viewed 153 times.
Message	Decided to go ahead and pull the motor on my Z. I plan on changing all vaccume lines doing the egr delete. Replacing wiring harness, turbos, new down pipes, plenum gasket, clutch, flywheel. Is there anything I am missing? Done some searching found the how to on the removal and some things that are recommended to replace but wondering if anyone has any other info that might save me doing it again later. Thanks Guys!
Follow Ups	Pulling motor - Nis300owner 16:29:08 10/09/07 Take your time, lable things. (n/m) - YugoBernie (NoVA) 16:58:52 10/09/07 Label everything you can. I took pictures and tried to - ELDIABLO 17:25:52 10/09/07 Did you ever get the oil problem solved? (n/m) - doug8867 21:17:42 10/09/07 High pressure power steering hose if needed (n/m) - TTFairladyZ 17:00:01 10/09/07 2nd, glad mine didn't need it. (n/m) - BlackholeZ 17:03:00 10/09/07 that can be done with the motor in. - spyhunterTT(nj) 17:27:31 10/09/07 Yes, but I'd much rather do it when its out (n/m) - TTFairladyZ 17:44:18 10/09/07 UR & HI pulleys - BlackholeZ 17:02:14 10/09/07 Those are not necessities. They can be done with the motor - Alex (SoFL) 17:07:46 10/09/07 Did you read his post or just the title? (n/m) - YugoBernie (NoVA) 17:16:13 10/09/07 It's not hard to remove a radiator and install a UR and HI - Alex (SoFL) 17:23:24 10/09/07 LOL thanks Bernie - BlackholeZ 17:47:36 10/09/07 It all depends on how you look at the question that was - Alex (SoFL) 17:53:39 10/09/07 agreed - BlackholeZ 18:10:39 10/09/07 Thanks guys that really helped! (n/m) - Nis300owner 22:25:48 10/09/07 detonation sensor harness (n/m) - robo (sebring1970) 17:04:36 10/09/07 Replace the small water hose & main oil seal on the back - lewoolf2 17:55:13 10/09/07 See what you started? (n/m) - scottyfender 18:12:54 10/09/07 if you are ocd, t bolt clamps all around - gt300zxtt 19:13:58 10/09/07 There's a point between what's necessary and ocd - TTFairladyZ 19:59:25 10/09/07 I thought it was the powdercoating the bolts & washers. - BlackholeZ 21:20:53 10/09/07 uniformity - gt300zxtt 21:31:50 10/09/07
Post a Followup	You cannot reply to this message because you are not logged in.