Subject	he is talking about the intake manifolds not the exhaust
Posted by	Carlos Ramirez on October 07, 2007 at 7:00 AM
	This message has been viewed 78 times.
In Reply To	Extrude honed manifolds posted by 550HPTT on October 06, 2007 at 05:02 PM
Message	So thats not the same as MS manifolds. Also there is an imbalance in the factory intake manifold. However when extrude honing the lower intake manifold you have to be careful that you have the heads matched and not have air just slam into a wall. Because the hole on the heads is smaller than the lower intake manifold.
Follow Ups	Extrude honed manifolds - 550HPTT 17:02:31 10/06/07 Why would you go this route instead of spending a bit more - S.Watson 17:17:04 10/06/07 I have RZT Tubular exhaust manifolds, Upper & Lower Intake - 550HPTT 17:27:42 10/06/07 My bad. Guess I should have read the entire post. (n/m) - S.Watson 17:32:43 10/06/07 Don't waste your money - ZXRider(SoCal) 17:21:15 10/06/07 read (n/m) - collegeboy 17:39:37 10/06/07 I have heard - collegeboy 17:40:36 10/06/07 Im trying to do as much external work as i can before i - 550HPTT 17:50:12 10/06/07 I agree especially with forced induction. (n/m) - FantasyZ 21:33:16 10/06/07 more air moving before spool up = faster spool up? - 550HPTT 22:31:36 10/06/07 which place? bonehead by chance? (n/m) - spyhunterTT(nj) 19:34:23 10/06/07 he is talking about the intake manifolds not the exhaust - Carlos Ramirez 07:00:35 10/07/07
Post a Followup	You cannot reply to this message because you are not logged in.