Subject	My bad. Guess I should have read the entire post. (n/m)
Posted by	S.Watson on October 06, 2007 at 5:32 PM
	This message has been viewed 40 times.
In Reply To	I have RZT Tubular exhaust manifolds, Upper & Lower Intake posted by 550HPTT on October 06, 2007 at 05:27 PM
Message
Follow Ups	Extrude honed manifolds - 550HPTT 17:02:31 10/06/07 Why would you go this route instead of spending a bit more - S.Watson 17:17:04 10/06/07 I have RZT Tubular exhaust manifolds, Upper & Lower Intake - 550HPTT 17:27:42 10/06/07 My bad. Guess I should have read the entire post. (n/m) - S.Watson 17:32:43 10/06/07 Don't waste your money - ZXRider(SoCal) 17:21:15 10/06/07 read (n/m) - collegeboy 17:39:37 10/06/07 I have heard - collegeboy 17:40:36 10/06/07 Im trying to do as much external work as i can before i - 550HPTT 17:50:12 10/06/07 I agree especially with forced induction. (n/m) - FantasyZ 21:33:16 10/06/07 more air moving before spool up = faster spool up? - 550HPTT 22:31:36 10/06/07 which place? bonehead by chance? (n/m) - spyhunterTT(nj) 19:34:23 10/06/07 he is talking about the intake manifolds not the exhaust - Carlos Ramirez 07:00:35 10/07/07
Post a Followup	You cannot reply to this message because you are not logged in.