Subject	One suggestion -- might want to put a piece of
Posted by	jzack on October 01, 2007 at 6:56 PM
	This message has been viewed 67 times.
In Reply To	My PTU reroute posted by BlackholeZ on October 01, 2007 at 06:26 PM
Message	split wire loom over the 12 inch run going to the Coolant and Temp guage plugs - makes it look more finished. I also used a little bit of cold shrink wrap tape on the loom end (near connectors) to keep it in place....
Follow Ups	My PTU reroute - BlackholeZ 18:26:15 10/01/07 I used electrical tape wrapped spiral wrap on my reroute, - 240Z FeO2 18:55:09 10/01/07 One suggestion -- might want to put a piece of - jzack 18:56:03 10/01/07 2nd on the split loom: - vorpalZ 21:43:43 10/01/07 I'm just really not a fan of that stuff. - BlackholeZ 21:59:05 10/01/07 *shrug* mine was done in the car - vorpalZ 23:05:23 10/01/07 The split loom solves the issue spyhunter was talking - jzack 00:01:23 10/02/07 Get some really small diameter loom, and place some - BigTDogg (MA) 12:08:39 10/02/07 Use shrink wrap, e-tape will come off eventually (n/m) - spyhunterTT(nj) 19:09:13 10/01/07 I'll have to throw some shrink wrap on there then. - BlackholeZ 20:51:18 10/01/07 simple - spyhunterTT(nj) 15:39:38 10/02/07
Post a Followup	You cannot reply to this message because you are not logged in.