TwinTurbo.NET: Nissan 300ZX forum - installing harness while motor in
People Seeking Info
 
   


     
Subject installing harness while motor in
     
Posted by fairZ on September 30, 2007 at 2:13 PM
  This message has been viewed 56 times.
     
In Reply To 2nd, I would have done the piping before also. (n/m) posted by lakerdude42 on September 30, 2007 at 01:18 PM
     
Message ok i have made the hole a bit bigger in the fire wall ... it is still a tight fit but i can do it.. i just need to wrap the ecu connector and the white connector together with electric tape to prevent the fire wall cutting and damaging the wires .... but i am not worried about that as much still will be a lil tough though :(

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.