TwinTurbo.NET: Nissan 300ZX forum - RE:::::::wiring tt swap
People Seeking Info
 
   


     
Subject RE:::::::wiring tt swap
     
Posted by fairZ on September 30, 2007 at 1:46 PM
  This message has been viewed 55 times.
     
In Reply To Also, you should have done the EFI harness first. posted by brahmabull (CT) on September 30, 2007 at 01:15 PM
     
Message i didnt see a dent on the oil pan ... so hopefully all is well there ....and about the harness i had a 90-93 tt harness installed before i dropped in the motor ....but!!! i found out later (engine already in ) it was a a/t harness and it was cut and rewired ...:( no spark and wires were cut so bad ... so i yanked that harness out and i need to order a new harness ..... my problem is i dont know which one to get ....

my car is a 91 2+2 n/a 5spd and i have a 90-93 tt motor .. and i wanna make my current set up work with my n/a fuel pump and fuel pressure controller ..... also i have a tt ecu and a n/a ecu that is socketed already i just need a tt eprom chip ..which one should i use ???

i would like to have the boost solonoids and the fuel pump and fpc work together what set up should i go with ???

and yeah i will paint the car after i finish the swap ....i was thinking a burnt orange like lemans sunset or something like that ...

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.