Subject	You need to disconnect any hardpiping first
Posted by	robzone0911 on September 29, 2007 at 3:37 PM
	This message has been viewed 36 times.
In Reply To	South California, San Diego, posted by jobambo on September 29, 2007 at 03:33 PM
Message	Then you need to get a jack to lift the front of the motor at the crank. Then it should slide right in. If you want I can come do it for you for a "nominal" fee Before Swap After Swap
Follow Ups	CALLING ALL SAN DIEGANS, Transmission help needed! - jobambo 21:57:21 09/28/07 Lift front of engine, And hopefully you used a Clutch align - Spddracer 00:32:47 09/29/07 Clutch is fully aligned and the tool slips in and out with - jobambo 14:21:55 09/29/07 Ok, still not going in. 100 bucks to the first person - jobambo 15:26:55 09/29/07 San diagoans, san diagoens, san diagans? (n/m) - Southern_Z [IL] ® 15:30:02 09/29/07 South California, San Diego, - jobambo 15:33:43 09/29/07 You need to disconnect any hardpiping first - robzone0911 15:37:03 09/29/07
Post a Followup	You cannot reply to this message because you are not logged in.