I'm going to do the ptu reroute on my new harness while the gettin's good. All the write-ups I've found the pics are dead. How far back do I have to split the loom? past the CAS plug? I'm thinking of splitting it down to where the loom splits for the fuse box & MAS. Correct? Any special electrical tape to recommend? I read in one write up Ash used some high quality 3m tape, where can I get it?
Sorry for all the questions lately, I'm stoked to be getting my Z running and I want it right. I don't really want to do this again.
Here's the photos to go with this.
Bent oil pickup
 Sparkly oil pan
 One of the larger bearing flakes I found in the oil pan
 Spun #6 journal and toasted #5
 On to the carnage, #4 Bearing
Macro RoolZ My work here is done. That's Joe, learning about the engine in his Z.
_____________Sig_____________   
"When Chuck Norris was denied an Egg McMuffin at McDonald's because it was 10:35, he roundhouse kicked the store so hard it became a Wendy's."
"When the boogey man goes to bed at night, he checks the closet for Chuck Norris."
"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"bashcomesinandpostallhiswishdomonthisin85432pagesofBS (n/m)" - Halo Z "Z32 it will get you for life" - Smitytec "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne |
PTU Reroute? & Photo update - 
