TwinTurbo.NET: Nissan 300ZX forum - Yes it is tough....
People Seeking Info
 
   


     
Subject Yes it is tough....
     
Posted by BOOZTD 3 on September 24, 2007 at 12:17 PM
  This message has been viewed 68 times.
     
In Reply To Re: Drivers door is finished and installed..... posted by merlin3 on September 23, 2007 at 05:36 PM
     
Message but it just takes patience and learning how to manipulate the material correctly. I bought some tongue depressors and used that to tuck the material into the crevices where the suede meets the vinyl. I then pressed really hard on the tongue depressor so it would make a mark on the material where it was going into the crevice the deepest. I'd then cut the material just a hare longer past the mark. The material tucks nicely down in those crevices

As far as getting the wrinkles out, you'll just need to work on stretching the material in the proper places












     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.