TwinTurbo.NET: Nissan 300ZX forum - Re: Drivers door is finished and installed.....
People Seeking Info
 
   


     
Subject Re: Drivers door is finished and installed.....
     
Posted by merlin3 on September 23, 2007 at 5:36 PM
  This message has been viewed 64 times.
     
In Reply To Drivers door is finished and installed..... posted by BOOZTD 3 on September 22, 2007 at 11:21 PM
     
Message when I did mine I couldn't find any good suede at jo-ann's it was all real cheap thin stuff. I ended up using a light gray ultrasuede that I purchased off a dealer on ebay. Mine turned out good except the door panels, I am not at all happy with them. What did you do where the suede meets the plastic on the door on the top and bottom. I could not find a good way to make those two meet and also it is really hard to do the end of the door by the vent that meets up with the vent in the car. the way the door curves and everything it is really difficult to not get any wrinkles.

1990 300zx 2+2 twin turbo, 2003 350z greddy twin turbo

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.