TwinTurbo.NET: Nissan 300ZX forum - I found that the portion of the engine harness that
People Seeking Info
 
   


     
Subject I found that the portion of the engine harness that
     
Posted by zgene4 on September 18, 2007 at 11:33 PM
  This message has been viewed 78 times.
     
In Reply To Good luck on putting that wood panel back on posted by Spectrum (WI) on September 18, 2007 at 11:30 PM
     
Message actually attaches to the ECU needs to be rotated back 180 before being connected to the piggy-back harness. I also ditched the ECU mounting bracket as there was enough bracing from the two harness and the ZEM wiring to hold it in place. I was then able to get the woof floorboard back in place w.o much issue.


"Too dumb for opera, too smart for NASCAR."

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.