Subject	Engine removal
Posted by	Nis300owner on September 13, 2007 at 12:12 AM
	This message has been viewed 672 times.
Message	Finally time for some good upgrades. I bougth a Jeep for teh winter so I dont need to use the Z from here until next spring. I am planning on pulling the motor and trans and doing some upgrading and maintance. My timing belt and all the were changed 10k ago but I want to upgrade/replace the following Down pipes wiring harness Remove egr Turbos Under drive pully replace vacume lines and gaskets Replace battery cables Thats about all I have found in my searching is there anything I am missing? What turbos will get me to around 500hp and arn't really expensive but reliable. Not looking to cheap out just want prices to stay at a decent level. Thanks for any help guys!
Follow Ups	Engine removal - Nis300owner 00:12:17 09/13/07 HI Pulley should go w. your UR install... - YugoBernie (NoVA) 00:24:31 09/13/07 will that thing further increase cooling if i run it on a - nemo1080 01:16:20 09/13/07 because it's smaller than stock correct? (n/m) - nemo1080 01:17:20 09/13/07 Not recommended because it can cause cavitation. (n/m) - ZDUCTIV 02:25:31 09/13/07 "500hp" and "aren't really expensive" don't go together - apudapus 01:03:41 09/13/07 i like mine, but am ready for 530's already! (n/m) - nemo1080 01:04:44 09/13/07 530s with 4.10 leader gears = Fun car (n/m) - Eishozzzz 03:41:23 09/13/07 I think thats the plan thanks (n/m) - Nis300owner 08:29:03 09/13/07 Don't forget the drag radials. (n/m) - bbug 13:43:26 09/13/07 2k miles every month - awesom-o 09:27:40 09/13/07
Post a Followup	You cannot reply to this message because you are not logged in.