Subject	2.0mm head gasket, all things being equal, will make your
Posted by	got rice? on May 27, 2001 at 8:49 PM
	This message has been viewed 25 times.
In Reply To	I run the 2mm metal head gaskets as well. I didn't posted by BadZCar (FL) on May 27, 2001 at 08:01 PM
Message	compression ratio change from 8.5:1 to 7.85:1, if the bore is 3.43 and the stroke is 3.27 Later, Phuong Rice Land
Follow Ups	Is anybody running TDO5 with stock compression ratio? - Chip 19:24:53 05/27/01 in addition - AntiHero[Z-Less] 19:47:01 05/27/01 I run the 2mm metal head gaskets as well. I didn't - BadZCar (FL) 20:01:34 05/27/01 2.0mm head gasket, all things being equal, will make your - got rice? 20:49:24 05/27/01 Damnit GR, every time I see your sig I bust out laughing. - BadZCar (FL) 21:05:28 05/27/01 With the 1.5mm, the compression is.. - Good2Zya 21:00:25 05/27/01 actually I believe Fred has the 1.2mm headgaskets>>> - 97 S14 20:15:54 05/27/01 No, mine are 2mm also. (n/m) - Good2Zya 20:56:25 05/27/01 compression ratio is a volumetric ratio and not - got rice? 20:38:03 05/27/01 But, lower comp. ratio will decrease power, so - Chip 21:02:13 05/27/01
Post a Followup	You cannot reply to this message because you are not logged in.