Subject	My rears are 18's and I tried that as a temporary solution
Posted by	zgene4 on September 09, 2007 at 10:56 PM
	This message has been viewed 43 times.
In Reply To	I wonder if 18" integrals would clear... posted by Wingnuttzx on September 09, 2007 at 10:49 PM
Message	to get the car out of the garage but the tires hit the suspension (18X9 275) so that doesn't really help anybody. My front wheels are +38 and I run 5mm hubcentric spacers to clear the calipers on stock rotors. It would seem that 18 diameter would help the spoke not curve in as much at the point it overlaps with the caliper, but it would all depend on your wheel offset and width. "Too dumb for opera, too smart for NASCAR."
Follow Ups	I was almost proud of myself - zgene4 22:14:33 09/09/07 Ugh, that stinks. Good luck with the Wilwoods. Hope they fit - Eric(NJ) 22:19:29 09/09/07 Is it just the nissan logo that is not clearing? (n/m) - marioz32tt (San Antonio) 22:23:26 09/09/07 Well, that's the first obstruction. I'm not even sure - zgene4 22:49:30 09/09/07 I would have had the same situation - SilverTwin(OH) 22:24:06 09/09/07 I wonder if 18" integrals would clear... - Wingnuttzx 22:49:15 09/09/07 My rears are 18's and I tried that as a temporary solution - zgene4 22:56:47 09/09/07 That sucks, but enjoy the Wilwoods. - collegeboy 22:54:41 09/09/07 Nice. I used the same Eibach kit... - BradZ (FL) 23:22:50 09/09/07 ha ha! been there man. (n/m) - nemo1080 23:25:08 09/09/07 Looking good!!! (n/m) - Coz@CZP 23:55:19 09/09/07 Did you read his post? :) (n/m) - Eishozzzz 02:32:30 09/10/07 Re: I was almost proud of myself - kr4usy 00:00:08 09/10/07 You can grind down the Nissan logo and 2mm more, i did it - Eishozzzz 02:44:59 09/10/07 Aren't those studs for the front wheels, rear's are supposed - WildBill 12:27:07 09/10/07 Wilwoods-I love my set-up! 12.2" is plenty of stopping power - Hawkin"Z" 13:56:40 09/10/07 sent him an email about my time frame issue, no reply as - zgene4 18:48:35 09/10/07 Buy the Eibach set for the Maxima. (n/m) - YugoBernie (NoVA) 17:25:16 09/10/07 Just looked at my invoice and it was for 05-06 Maxima - zgene4 18:47:58 09/10/07
Post a Followup	You cannot reply to this message because you are not logged in.