| Message |
It works rather well for most bushings on the Z. That said, the only thing you really need it for, is doing tension rod bushings. Everything else can be done with conventional means (i.e. burn it out, wirebrush, then sawzall the rest and air chisel if necessary). It does work rather well for doing throw out bearings and a number of other small things. If I had it to do over again, I'd get one that was taller. This one is rather low to the ground so you're either sitting, or kneeling. Other than that, it is sufficient enough to do most jobs on the Z, provided you have a decent torch (actylene or better).
Alex 
|
 |
