Subject	Try searching on ceramic turbine instead >>
Posted by	Ted (92TT) on September 07, 2007 at 7:30 PM
	This message has been viewed 53 times.
In Reply To	Ceramic Impellers??? posted by 550HPTT on September 07, 2007 at 04:37 PM
Message	It has been discussed quite a bit in the past. If you're referring to the compressor side (impeller) I haven't seen anything on that. The turbine side can theoretically benefit from the high heat resistance and lighter weight, but it's been discussed that ceramics are prone to failure at the high RPMs encountered. Scotts94z32 has posted some good stuff on this.
Follow Ups	Ceramic Impellers??? - 550HPTT 16:37:34 09/07/07 Try searching on ceramic turbine instead >> - Ted (92TT) 19:30:32 09/07/07 if ceramic is on exhaust side, you don't want it. (n/m) - nemo1080 00:54:59 09/08/07 Re: if ceramic is on exhaust side, you don't want it. - Marty1Mc 02:07:22 09/08/07 1bar is not really a "standard", but they are currently - Scotts94z32 14:42:00 09/08/07
Post a Followup	You cannot reply to this message because you are not logged in.