Subject	Good luck
Posted by	spyhunterTT(nj) on August 20, 2007 at 2:46 PM
	This message has been viewed 29 times.
In Reply To	Yeah posted by Nis300owner on August 20, 2007 at 12:44 PM
Message	If you're fortunate enough to have a low mileage car, it may come off easily. I've only had one 60k mile 95TT that came off easily with a wrench. Every other car, I've had to cut the pipe off, then put a socket on it and a long ratch to move it. 22mm. I think I used an opened ended wrench and a hammer a few times too. All cases were with the engine out of the car. Best of luck Alex
Follow Ups	Question quik - Nis300owner 12:35:54 08/20/07 uhhh did you block the fittings on the plenum? - spyhunterTT(nj) 12:42:37 08/20/07 Yeah - Nis300owner 12:44:35 08/20/07 Good luck - spyhunterTT(nj) 14:46:29 08/20/07 I believe the hex head size is 22mm - cut the pipe out and - YugoBernie (NoVA) 12:44:25 08/20/07 I used a 7/8" crows foot... - pionkej 13:26:11 08/20/07 a 7/8" normal length open-ended wrench works fine. - ThunderZ 13:30:50 08/20/07 ITS NOT A 7/8"! What else is it? (n/m) - Nis300owner 16:26:26 08/20/07
Post a Followup	You cannot reply to this message because you are not logged in.