Subject	a 7/8" normal length open-ended wrench works fine.
Posted by	ThunderZ on August 20, 2007 at 1:30 PM
	This message has been viewed 21 times.
In Reply To	Question quik posted by Nis300owner on August 20, 2007 at 12:35 PM
Message	Just remove the driver downpipe and it's easy to access. The normal length 7/8" wrench makes it easier to loosen the bolt as opposed to a stubby.
Follow Ups	Question quik - Nis300owner 12:35:54 08/20/07 uhhh did you block the fittings on the plenum? - spyhunterTT(nj) 12:42:37 08/20/07 Yeah - Nis300owner 12:44:35 08/20/07 Good luck - spyhunterTT(nj) 14:46:29 08/20/07 I believe the hex head size is 22mm - cut the pipe out and - YugoBernie (NoVA) 12:44:25 08/20/07 I used a 7/8" crows foot... - pionkej 13:26:11 08/20/07 a 7/8" normal length open-ended wrench works fine. - ThunderZ 13:30:50 08/20/07 ITS NOT A 7/8"! What else is it? (n/m) - Nis300owner 16:26:26 08/20/07
Post a Followup	You cannot reply to this message because you are not logged in.