Subject	I believe the hex head size is 22mm - cut the pipe out and
Posted by	YugoBernie (NoVA) on August 20, 2007 at 12:44 PM
	This message has been viewed 32 times.
In Reply To	Question quik posted by Nis300owner on August 20, 2007 at 12:35 PM
Message	see about test fitting a socket on there to get the right sizing before you cut up wrenches - or buy a set stubies HI Overdrive Water Pump Pullies Are Here! Bernie Bilski berniebilski@cox.net 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red (some assembly required) 1995 Nissan Pick-Up XE in Super Black ZCCNV #390 ~ ECZA #368 Need INSTALLS, DIAGNOSTICS, SERVICE or PARTS in the NoVA/DC/MD area? Please email me or check out my current inventory.
Follow Ups	Question quik - Nis300owner 12:35:54 08/20/07 uhhh did you block the fittings on the plenum? - spyhunterTT(nj) 12:42:37 08/20/07 Yeah - Nis300owner 12:44:35 08/20/07 Good luck - spyhunterTT(nj) 14:46:29 08/20/07 I believe the hex head size is 22mm - cut the pipe out and - YugoBernie (NoVA) 12:44:25 08/20/07 I used a 7/8" crows foot... - pionkej 13:26:11 08/20/07 a 7/8" normal length open-ended wrench works fine. - ThunderZ 13:30:50 08/20/07 ITS NOT A 7/8"! What else is it? (n/m) - Nis300owner 16:26:26 08/20/07
Post a Followup	You cannot reply to this message because you are not logged in.