Subject	I think the way that should be interpreted is >
Posted by	SlicktopTT on August 16, 2007 at 1:01 PM
	This message has been viewed 37 times.
In Reply To	Calculating taper per the FSM "Taper (A-B-C)" posted by CaliguyPurdue (redesigning) on August 16, 2007 at 12:23 PM
Message	If A-B, B-C or A-C is greater than .0004 then there is too much taper. Example Mes A = 80.0003 Mes B = 80.0002 Mec C = 80.0001 No combination of subtraction should yield a diffence greater than .0004.
Follow Ups	Calculating taper per the FSM "Taper (A-B-C)" - CaliguyPurdue (redesigning) 12:23:46 08/16/07 Are you rebuilding your engine yourself? (n/m) - ZXRider(SoCal) 12:25:32 08/16/07 Yea, I'm putting together some very strict requirements - CaliguyPurdue (redesigning) 12:31:32 08/16/07 Why not just buy a IPP package and save yourself - ZXRider(SoCal) 12:47:30 08/16/07 Thats not how I roll ;) - CaliguyPurdue (redesigning) 13:18:47 08/16/07 scary, isn't it? - aliaZ 12:48:49 08/16/07 I think the way that should be interpreted is > - SlicktopTT 13:01:53 08/16/07 When an engine is bored out and honed, they should - AZHeat 13:31:34 08/16/07 Any chance you could send me what you have compiled? - J-Mart 14:00:31 08/16/07 No problem... I was planning on sharing the PDF's when - CaliguyPurdue (redesigning) 14:05:07 08/16/07 Nice. Please do share them. - ZXRider(SoCal) 14:07:06 08/16/07 Why not just buy a IPP package and save yourself - apudapus 17:27:48 08/16/07 Maybe by the time when I need a new engine - ZXRider(SoCal) 19:50:14 08/16/07 if documented would be a hellava tech doc - mossyoak 14:04:33 08/16/07 Taper would generally mean A-C, dont worry about B - imney 14:37:03 08/16/07 to calculate the difference from out of round and taper - imney 14:39:53 08/16/07
Post a Followup	You cannot reply to this message because you are not logged in.