Subject	Re: Converting to power seats....
Posted by	RightD on May 24, 2001 at 8:51 PM
	This message has been viewed 36 times.
In Reply To	quick Q about changing seats in the Z posted by MasterNimos on May 24, 2001 at 07:55 PM
Message	90s that came with the manual seats aren't pre-wired for power ones. You'll have to run a power line over to the inside fusebox. Easiest way to do that is to pull the kickpanel and the door sill plate, and then run the wire under the carpet. There is a small hole in the carpeting directly under the seat where the seatbelt sensor connector comes through. Good luck, - RightD
Follow Ups	quick Q about changing seats in the Z - MasterNimos 19:55:48 05/24/01 There's gotta be wiring there. I ain't sure if you can - Abel 2 Z's (Florida) 20:18:44 05/24/01 Re: Converting to power seats.... - RightD 20:51:30 05/24/01
Post a Followup	You cannot reply to this message because you are not logged in.