Subject	huh? i would not recomend doing it that way.
Posted by	AntiHero on July 27, 2007 at 2:01 PM
	This message has been viewed 31 times.
In Reply To	work from inside the hatch with the hatch open, posted by robo (sebring1970) on July 27, 2007 at 02:27 AM
Message	Do not thread into the sheetmetal, thats not helping anything. drill a hole just big enough for the screw pass through without any real interference. when you thread the sheetmetal you are taking away the screws ability to clamp the surfaces together. when you are "tightening" the only force you will be applying is between the head of the screw and the sheetmetal, and the weak threads in the fiberglass are being stressed. Antihero These 2530's ain't half bad ;)
Follow Ups	Right side of Zeta spoiler has come loose from hatch deck. - doug8867 20:02:51 07/26/07 Mine did the same thing. I just ran a small - Spddracer 20:23:37 07/26/07 screw, like Spddracer said - robo (sebring1970) 02:09:42 07/27/07 how to you get access to the old square hole? it appears - whatsthegoodword 02:16:52 07/27/07 work from inside the hatch with the hatch open, - robo (sebring1970) 02:27:23 07/27/07 huh? i would not recomend doing it that way. - AntiHero 14:01:17 07/27/07 I agree. I wrote *pilot hole* but what I really did was - robo (sebring1970) 14:35:46 07/27/07
Post a Followup	You cannot reply to this message because you are not logged in.