Subject	I tried every trick to get that auto bushing out
Posted by	TTFairladyZ on July 17, 2007 at 10:54 PM
	This message has been viewed 41 times.
In Reply To	Conversion update posted by 300twinz (satx) on July 17, 2007 at 10:05 PM
Message	Chisel, Prybar, pilot bushing puller, dowel with grease and then with wet newspaper, bolt similar size, etc... Made 3 pie cuts with a dremel, tapped it towards the center with a hammer, out in 3 minutes.
Follow Ups	Conversion update - 300twinz (satx) 22:05:14 07/17/07 Should have just just used the n/a clutch master cylinder (n/m) - nissanguyz32 22:13:01 07/17/07 are you talking about the bushing for the auto that is - Halo Z 22:39:00 07/17/07 yeah he is talking about the converter bushing. - nissanguyz32 22:49:15 07/17/07 I'm down to just using a hammer and vice grips now. - Woody75 (Denver) 08:50:39 07/18/07 I use that "trick" all the time - 1badz32 (MN) 09:15:45 07/18/07 yep, it works wonders. - apudapus 13:57:15 07/18/07 I tried every trick to get that auto bushing out - TTFairladyZ 22:54:51 07/17/07 should have just used the n/a clutch assembly (n/m) - Guapo 22:57:28 07/17/07 glad to see it's moving along and you didn't have - sfarrah 23:30:56 07/17/07 hey Sean! All I have left is some wiring, - 300twinz (satx) 23:45:51 07/17/07 Are you doing a 5spd conversion? (n/m) - ZXRider(SoCal) 01:15:49 07/18/07 yes he is (n/m) - Ahmed (aka PakiHomBoy) 01:38:14 07/18/07 It's great to see all of these conversions going on. - brahmabull (CT) 08:49:20 07/18/07 I used this to remove my auto bushing - sino26 12:32:37 07/18/07
Post a Followup	You cannot reply to this message because you are not logged in.