Subject	damn!!!!!!
Posted by	Brbcas on May 24, 2001 at 8:48 AM
	This message has been viewed 10 times.
Message	I changed out my break pads yesterday and afterwards me and a couple of buds went out and eat at bennigans...on my way back i heard a really bad rubbing noise...well i started to pull over and right as i began to slow down my breaks locked up...well i got the jack to what the matter was...and i notice that one of the two bolts was missing the caliper moved complety around...well we walk about 1/4 mile down the st looking for the damn screw...NO LUCK.. well we got back to my car and i looked again and noticed that the screw wasnt gone, but the damn thing broke in half...would tightening it to tight cause this or could some1 help me out?
Follow Ups	damn!!!!!! - Brbcas 08:48:18 05/24/01 you don't need to undo any screws to change the pads>>> - my91z(500hp NA) 08:53:35 05/24/01 Re: you don't need to undo any screws to change the pads>>> - Brbcas 08:55:12 05/24/01
Post a Followup	You cannot reply to this message because you are not logged in.