Subject	Engine pulled and ready for maintenance. pics
Posted by	300zx1717 on July 16, 2007 at 7:06 PM
	This message has been viewed 596 times.
Message	Pulled my first 300zx engine. Took about 9 hours total. It was actually kinda easy compared to an mr2 engine. I used the great engine pull tech article from Damon. It was a great aid. It was probably easy too because the person before me that put the engine back did a piss poor job (not all the bolts were in the tranny, broken harness clips etc...). Now to do the 120k maintenace, eliminate the egr valve, reseal the valve covers, and replace the transmission harness and the efi harness. Hopefully the engine goes back in just as easy. Is there anything else I can eliminate? I am going to do the throttle body bypass, eliminate the egr, the aiv is gone, but I havent removed all the vacum lines....Would like to get rid of as much clutter as possible...enjoy the pics -Rob
Follow Ups	Engine pulled and ready for maintenance. pics - 300zx1717 19:06:54 07/16/07 Yeah carbon can delete (n/m) - Die V10 19:18:03 07/16/07 you can always clean the engine bay (n/m) - imney 19:40:08 07/16/07 Not bad for the first time - TTFairladyZ 19:41:26 07/16/07 Re: Not bad for the first time - zleepertt(MD) 20:01:17 07/16/07 Sorry, no pics of the install - TTFairladyZ 20:22:33 07/16/07 Is pulling the motor on an MR2 that difficult? - 952+2TT 19:42:42 07/16/07 I pulled the transmissio on my first engine pull on the mr2 - 300zx1717 20:29:49 07/16/07 "Would like to get rid of as much clutter as possible..." - NAZTTy 19:53:32 07/16/07 Re: "Would like to get rid of as much clutter as possible..." - 300zx1717 20:23:59 07/16/07
Post a Followup	You cannot reply to this message because you are not logged in.