Subject	If the holes arent completly stripped you could
Posted by	EricTTZ on July 08, 2007 at 8:21 PM
	This message has been viewed 54 times.
In Reply To	retapping the plenum balance tube stud(s)..what sizes posted by genic on July 08, 2007 at 06:51 PM
Message	run an m8x1.25 tap through and be done with it. Otherwise a ~$30 m8x1.25 helicoil kit available at any auto parts store should do the trick. I personally would not do the balance tube with the plenum installed for fear of shavings getting in the plenum. If its just the coil packs then it should be a breeze. Good luck. AIM: EricTTZ
Follow Ups	retapping the plenum balance tube stud(s)..what sizes - genic 18:51:36 07/08/07 I can't recall the size but coat the tap with grease to hold - Dave N 19:13:28 07/08/07 should be m8 @ 1.25 - spyhunterTT(nj) 19:45:33 07/08/07 LOL, I was way off. I'm glad you chimed in with the correct - Dave N 19:52:00 07/08/07 2nd did it the other day cause z1 sent me one - DaRealDefaulTT 20:40:10 07/08/07 shocking (n/m) - genic 22:32:30 07/08/07 If the holes arent completly stripped you could - EricTTZ 20:21:17 07/08/07 yea..the balance tube will be off the plenum - genic 20:52:19 07/08/07 You dont want to get a larger size tap. - EricTTZ 21:01:46 07/08/07 tks a lot...where did you pick up the helicoil tool from? (n/m) - genic 21:03:51 07/08/07 Autozone has them but i think advanced auto - EricTTZ 21:13:58 07/08/07 tks boss (n/m) - genic 22:30:56 07/08/07 thouse ALWAYS strip (n/m) - 300znick 01:44:16 07/09/07 hence why i need to RE-TAP THE DAMN THINGS! (n/m) - genic 17:31:05 07/09/07 One of my bolt holes was stripped so bad that I couldn't - Kelticttz 17:41:46 07/09/07
Post a Followup	You cannot reply to this message because you are not logged in.